Pipewise

About

Pipewise is a pipe fitter calculator for the job site. Type your numbers the way you read them off the tape, like 3' 4 1/2, and get travel, run and cut length with a drawing that shows what you are cutting.

Offsets

Simple offsets from any two of offset, run, travel or angle. Rolling offsets by fitting angle or by a fixed run. Multi-pipe offsets for 2 to 6 parallel lines, with the start shift for each line so the bank stays even.

Cut Length

Subtract both elbow take-outs and your weld gap in one step. If the fittings do not fit, Pipewise tells you how much you are short.

Fittings

Take-out for any elbow angle, long radius, short radius, 3R or your own radius. Cut any angle out of a 90 with heel, throat and centerline marks. Miter elbows from 2 to 8 pieces, any total angle.

Wrap-Around Templates

Miter cuts, branch fishmouths at any angle from 15 to 90 degrees, reducing branches, offset branches, and the matching hole in the header. See the curve on screen, read the ordinate table at 16 or 32 stations, or print a true-scale PDF on Letter or A4 with a check square so you know it printed at full size.

Pipe Weight And Volume

Weight per foot or per metre for carbon steel, stainless, copper, aluminum, PVC or your own density. Water weight and gallons for hydro tests and rigging, and totals for any length.

Your Own Pipe Table

A short starting table from 1/2 to 24 inch. Edit any OD, wall or elbow radius to match the material on your job, or add your own sizes.

Conversions

Feet, inches and fractions, mm and metres, psi, kPa, bar and feet of water, gallons and litres, pounds and kilograms, temperature, and slope in inches per foot, percent or degrees.

By Voice

Say "Offset travel in Pipewise" or "Rolling offset in Pipewise" and get the travel without opening the app.

Nothing To Renew

There is no plan to sign up for and no ad between you and the numbers. Everything runs on your iPhone, with no signal needed. Imperial or metric, fractions to 1/8, 1/16 or 1/32.

Always check critical cuts against your fittings before you cut. Pipewise does not include flange or tee dimension tables.